Chrysler Conquest 1988 Service Manual page 1220

21-98 AUTOMATIC TRANSMISSION - Automatic Transmission Assembly
Between oil pump
Between drum support
and O.D. case
to transmission case
JATlM
7
Spacer [I5 mm (.59 in.) thick]
I
i
159 Transmission case JAT'
I)
Front
IAT
Bearing race
r Oil pump
.'
Gasket
,-.
/- ',A,-L
t
F
L
O.D. case
case
4: O.D. iotaTend 6lai I
'"17-d
i Connecting drum
cf&&-- O.D. sun gear
fp
O.D. carrier
Upward
Sea1 sleeve
O.D. internal gear-
Direct clutch
assembly
\ A.-.
JAT162
I-
.__--
i \ 'i
,
21. Mount drum support gasket on drum support after coating
~:
with petroleum jelly. Apply automatic transmission fluid to :_
O-ring of drum support. AKgn drum support with O.D. case
I
to transmission case and install.
Before iristalliing drum support and O.D. case on transmis- ;
sion case, ensure that they have been centered properly.
Refer to Compornent Service Drum Support on page
21-107. -~
Install O.D. case, and temporarily tighten it using two ~;
converter housi~ng securing bolts.
=+
22. Insert intermediate shaft-being especially careful of its
direction.
23. Adjust O.D. back end play and O.D. total end play as ~I
follows:
(1) AssembleTdirect clutch assembly, O.D. planetary gear
set and connecting drum, and install them on O.D. pack.