Chrysler Conquest 1988 Service Manual page 753

ENGINE
- Front Case, Oil Pump and Silent Shaft
9-53
Cylinder block
front surface
MD998251 Beiring
Cylinder block
5ENOZ
Cylinder block
5EN023
L
,
Apply engine oil
5ENOZt
O-ring
5EN02E
der block
: shaft
5EN02:
SlLENT SHAFT BEARING REPLACEMENT PROCE-
DURE
NOSREAA
(1) Using the special tool, remove silent shaft rear bearing.
(2) Apply engine oil to O.D. of bearing. Using the special tool,
install silent shaft bearing to cylinder block.
SERVICE POINTS OF INSTALLATION
NOSRDCA
33. INSTALLATION OF LEFT SILENT SHAFT
(1) Apply engine oil to journal of left silent shaft.
(2) Insert left silent shaft into cylinder block. Insert silent
shaft carefully to prevent damage to the bearing.
31. INSTALLATION OF O-RING
(1) Install O-ring in groove of thrust plate.
(2) Apply engine oil around O-ring.
l +
30. INSTALLATION OF THRUST PLATE
(1) Install two guides in threaded holes for mounting thrust
plate. Guides should be fabricated by cutting off
hexagon heads of bolts 6 mm (.24 in.) in diameter and
50
mm (1.97 in.) long.
(2) Install thrust plate into cylinder block -along guides.
em
Without use of guide, threaded holes will be hard to
align.