Chrysler Conquest 1988 Service Manual page 365

CHARGING SYSTEM
- Service Adjustment Procedures
8-115
REGULATED VOLTAGE TEST
The purpose of this test is to check that the electronic voltage
regulator controls the voltage correctly.
Preparation
(1) Prior to the test, check the following items and correct if
necessary.
(a) Check the battery installed on the vehicle to see that it
is fully charged. For battery checking method, see
"BATTERY".
(b) Check the alternator drive belt tension. For belt tension
check, see "GROUP 7 COOLING".
(2) Turn the ignition switch to "OFF".
(3) Disconnect the battery ground cable.
(4) Connect a digital voltmeter between the "S" terminal of the
L
alternator and ground. Connect the (+) lead of the volt-
meter to the "S" terminal of the alternator, inserting from
the wire side of the 2-way connector and connect the (--)
lead to sound ground or battery (-) terminal.
r
Ignition
-. . .:+,.C. Alternator
) qyfl-
?ter
/Voltmeter -
I Ammo
Battery
-w Load
6EL252