Chrysler Conquest 1988 Service Manual page 1216

m-
_3_
---
21-94 AUTOMATIC TRANSMISSION
- Automatic Transmission Assembly
12. Install snap ring on shaft.
JAT143
-0.D. case
iru??~on ),,,,,- Gasket
Clutch pack '
1: Front end play
2: Total end play JAT144
AT145
13. Secure thrust bearing and thrust washer with petroleum
jelly and install rear planetary carrier.
14. Install rear planetary
carrier
snap ring.
.-
5--
This snaps ringis thinner than a clutch drum snap ring so be
g
sure you are using correct size. If you have insufficient .I
E
space to install snap ring-into drum groove, pull connecting
z
drum forward as far as possible. This will give you sufficient
ii=
groove clearance to install drum snap ring.
e
15. Adjust
front'end play as follows:
(1) Assemble high-reverse clutch (Front) and forward ~;
clutch (Rear), front internal gear, front planetary carrier.
and connecting shell. Secure thrust bearings with
petroleum jelly.