Chrysler Conquest 1988 Service Manual page 1058

REAR AXLE
- Differential Carrier
_
C-3893
11
llY21i
Drive pinion rear shim r
SERVICE
POINTS OF REASSEMBLY
NO3lNBD
20. INSTALLATION OF DRIVE PINION REAR BEARING
OUTER RACE / 19. DRIVE PINION FRONT BEARING
OUTER RACE
Press-fit the drive pinion front and rear bearing quter races ~.;
- into the gear carrier by using the special tools.
Caution
Perform press-fitting carefully so as not to tilt the outer
race.
l
PINION HEIGHT ADJUSTMENT
Adjust the drive pinion height by the following procedure: I
(1) Install special tools and drive pinion front and rear-
bearing inner races tcrthe gear carrier in the sequence
shown in the illustration.
NOTE
Apply a thin coat of the specified grease to ihe mating-.=:
face of -the washer of the special tool.
Specified grease: MOPAR Multi-Mileage Lubricant -
Part No. 2525035 or equivalent
--~
(2) Tighten the nut of the specral tool until the standard--,
value of -drive pinion- preload is obtained. _ _
(3) Measure the drive prnron rotatrng torque (wrthout the oil
seal).
Standard value: 15 - 25 Ncm (1.3 - 2.2 in.lbs.1
NOTE
-
Gradually tighten the nut of the special tool while?
checking the drive pinion rotating torque. ~.
(4) Positionthe special tool in the side beanng.seat of the ;
gear carrier, and thenselect a drive pinion rear shim of a
thickness which corresponds to the gap between the
special tools. _~
--
NOTE
Be sure to clean the side bearing seat thoroughly. When
position&g the spec$al tool, be sure that the c&ou~~ _ --
sections of the special tool are in the position shown in l
the illustration, and also confirm that the special tool is
in close. contact with the side bearing seat.
When selecting the drive pinion rear shims, keep the" ~'