Chrysler Conquest 1988 Service Manual page 1138

MANUAL TRANSMISSION
- Transmission
O.D. x length mm (in,) b
9. REMOVAL OF TRANSMISSION ASSEMBLY
(1) Remove the transmission mounting bolts (two bolts on
the upper- side) fromthe bell housing.
(2) Remove the remaining transmission mounting bolts.
(3) Support the transmission with a jack.
(4) Remove -the engine:support bracket and- insulator
assembly with the ground cable which is tightened
together with the insulator.
(5) Lower the transmission as shown in the Tffustration.
NOTE ~~~_ =
Place a piece of cloth on the rear of the cylinder head to ~1
prevent damage to the toeboard.
Remove~the-gearshiftjever assembly while the lever is I
in the neutral positio~n.
(6) Remove the transmission by pulling it toward the rear of
the vehicle.
SERVICE POINT OF INSTALLATION
NZlMDAE
9. INSTALLATION OF TRANSMISSION ASSEMBLY
Note that transmission mounting bolts differ in size from
one place toanother.