Chrysler Conquest 1988 Service Manual page 1193

AUTOMATIC TRANSMISSION - On-vehicle Service
21-71
\ r Puller
ATOIE
JATOlS
EXTENSION OIL SEAL REPLACEMENT
1. Remove propeller shaft.
2. Remove extension oil seal use with suitable puller.
3. Apply coat of ATF to oil seal surface, then drive new seal
into place.
4.
Coat sealing lips with Vaseline, then install propeller shaft.
Refer to Propeller Shaft for installation.
PARKING COMPONENTS
1. Drain oil by removing oil pan.
2. Remove propeller shaft.
3. Remove speedometer cable from transmission, then re-
move speedometer sleeve assembly.
4. Support transmission with a jack and wooden block, then
remove rear mounting bolts.
5. Remove rear extension bolts, then remove rear extension
with rear mounting.
6. Remove control valve assembly. Refer to Control Valve
Assembly.
7. Inspect and repair parking components. Refer to Parking
Mechanism for inspection.
8. Install control valve assembly. Refer to Control Valve
Assembly for on-vehicle service.
9. Install rear extension, then install rear mounting parts.
IO. Install speedometer sleeve assembly and cable.
11. Install propeller shaft. Refer to Propeller Shaft for installa-
tion.
12. Install oil pan with new gasket.
Oil pan bolts: 5 - 7 Nm (3.6 - 5.1 ftlbs.)
13. Refill with automatic transmission fluid.