Chrysler Conquest 1988 Service Manual page 1115

STEERING
- Power Steering Gear Box
19-29
19.
APPLICATION OF GREASE TO U-PACKING
(SIDE COVER SIDE)
(1
(2
) Apply specified grease to the seal surface of U-packing.
Specified grease: MOPAR Multi-mileage Lubricant
Part No. 2525035 or equivalent
I) Apply specified grease to the needle bearings.
Specified grease: MOPAR Multi-mileage Lubricant
Part No. 2525035 or equivalent
20. APPLICATION OF AUTOMATIC TRANSMISSION FLUID
TO O-RING
Apply specified fluid to the O-ring, and attach it to the side
cover.
Specified fluid: MOPAR DEXRON or DEXRON II Auto-
matic Transmission Fluid Part No.
3549660 or 4131509, or equivalent
25. INSTALLATION OF SIDE COVER
With the mainshaft in the neutr\al position, install the side
cover assembly (with the cross-shaft) to the gear box.
NOTE
Apply specified automatic transmission fluid to the teeth
and shaft areas of the rack piston, and apply specified
grease to the oil seal lip.
Specified fluid: MOPAR DEXRON or DEXRON II Auto-
matic Transmission Fluid Part No.
3549660 or 4131509, or equivalent
Specified grease: MOPAR Multi-mileage Lubricant Part
No. 2525035 or equivalent
Caution
Do not rotate the side cover during installation.
Take care not to damage the cross-shaft oil seal.
. ADJUSTMENT OF MAINSHAFT TOTAL STARTING
TORQUE
(1) While turning the adjusting bolt, measure the mainshaft
total starting torque by using the special tools.
Standard value: 50 - 90 Ncm (4 - 8 in.lbs.1
NOTE
Position the mainshaft in the neutral position during
measurement.
(2) Tighten the adjusting bolt lock nut.