Chrysler Conquest 1988 Service Manual page 979

AIR CONDITIONING
- Compressor
24-103
2OY94f
Y2071t
. REFILLING COMPRESSOR OIL
Pour the 115 cc (3.9 fl.oz.) or 170 cc (5.7 fl.oz.) of new
compressor oil into the service valves.
When only compressor has been removed:
115 cc (3.9 fl.oz.)
When entire refrigerant system has been replaced:
170 cc (5.7 fl.oz.)
1
8. INSTALLATION OF CLUTCH COIL
The clutch coil must be aligned with the pin in the
compressor housing.
5. INSTALLATION OF ROTOR ASSEMBLY
Clutch hub to rotor.assembly clearance must be checked
after installation.
MAGNETIC CLUTCH CLEARANCE
1. Tighten the clutch nut.
2. Check the clutch clearance as illustrated.
Pressure plate to rotor clearance:
0.4 - 0.7 mm (.02 - .03 in.)
NOTE
Remove clearance adjusting shims to decrease clutch
clearance. Add shims selected from the following table to
increase clutch clearance.
Clearance Adjustment Shims
1
3. Turn the rotor by hand to confirm that it rotates freely.