Chrysler Conquest 1988 Service Manual page 1194

__.- -. i
21-72
_______
AUTOMATIC TRANSMISSION
- On-vehicle Service
JATOZ:
Inhibitor
switch
/
-GOVERNOR VALVE ASSEMBLY
1. Drain oil by removing oil pan.
2. Remove rear~mqynting pa@, then remove rear extension. =
Refer to Parking Components.
3. Remove govmQr= valve assembly.
4. Inspect and repair governor valve assembly. Refer to
Governor forinspection.
5. Install governor valve ass_embly.
Governor valve mounting bolts:
5 - 7 Nm (3.6 - 5.1 ft.lbs.)
6. Install extensiorrthen inst-all rear mounting parts. Refer to
Parking Components.
7. Install oil panwrth new gasket.
Oil pan bolts: 5 - 7 Nm (3.6 - 5.1 fklbs.)
7.
INHIBITOR SWITCH ADJUSTMENT
The inhibitor switch- has twomajor functions. It causes the
back-up lights to illuminate when the shift lever is placed in the
Xv
reverses range. Its aleo acts as-3 neutral safety switch allowing
current to pass frQm the starter only when the lever isplaced in -1
the "P" or "N" ran-ge.
INSPECTION
A continuity tester may be used to check the inhibitor switch _:
for proper operation.
1. Check continuity at "N", "P" and "R" ranges.
._
2. With control lever held in Neutral, turn manual clever an '-
equal amount in both directions to see $-current flow 11~
ranges are nearly the same. (Current normally begins to .Y
flow before manual lever reaches an angle Qf J.52n either 'T
direction.)
L
If current flows outside normal range, or if nOrmal flow
range is out_ of specifications, properly adjust inhibitor -
switch.
._~
%
ADJUSTMENT
1. Place the manual valve i_rr Neutral (vertical position).
2. Remove the screw as illustrated.
3. Loosen the -attaching bolts.