Chrysler Conquest 1988 Service Manual page 829

FUEL (ECI) SYSTEM -
Service Adjustment Procedures
14-35
01 R0471
Engine speed
3FU25:
(20)Turn the ignition switch to ON (engine does not start) and
check that the TPS output voltage is as specified.
Standard value: 0.48 - 0.52 V
(21)lf it is not as specified, loosen the TPS mounting screws
and adjust by turning TPS.
NOTE
Turning TPS clockwise increases the output voltage.
Caution
Securely tighten the mounting screws after adjust-
ment.
(22)Set check switch of the ECI checker to OFF.
(23)Set ignition switch to "LOCK".
(24)Disconnect connectors of the ECI checker and the ECI
harness connector A from the ECU and the body side
harness connectors.
(25)Connect the body side harness connectors to the ECU.
(26)Adjust the accelerator cable free play. (Refer to P.14-126.)
(27)Connect ISC motor connector.
(28)Start the engine and check that the engine idle speed is as
specified.
Standard value: 850 + 100 rpm
(29)Turn the ignition switch to "OFF".
Disconnect the battery terminal fQr 5 to 6 seconds and then
reconnect it. (This erases the data stored in diagnosis
memory during the ISC adjustment.)
INJECTION MIXER INSPECTION
DISTRIBUTOR ADVANCE CONTROL VACUUM (D
VACUUM)
N14FUBA
Inspection Condition
Engine coolant temperature: 85 - 95°C (185 - 205°F)
(1) Disconnect the vacuum hose from the injection mixer D
vacuum nipple and connect a hand vacuum pump to the
nipple.
NOTE
For the location of the nipple, refer to the Injection Mixer
Appearance (P.14-31).
(2) Start and race the engine to make sure that D vacuum
increases with the engine speed.
NOTE
If abnormality is found in change of vacuum, clogged
injection mixer D port is suspected. Therefore, clean the
port as necessary.