Chrysler Conquest 1988 Service Manual page 1143

-xgp
-; d+&
MANUAL TRANSMISSION
- Transmission 21-17
132036
!I
SERVICE POINTS OF DISASSEMBLY
NZlMFBH
15. REMOVAL OF EXTENSION HOUSING
While pushing the change shifter down to left, remove
extension housing by pulling rearward.
,.
_
r
.Li
25.28. REMOVAL OF SPRINGr'PlNS
Using a pin punch, drive out the spring pins.
-7#2. REMOVAL OF MAINSHAFT LOCK NUT / 33. COUNTER-
SHAFT LOCK NUT
('I) Using blunt punch or chisel that has a blade as shown in
the illustration, bend back lock tabs of the mainshaft
and countershaft lock nuts.
(2) Shift the OD-R synchronizer sleeve in reverse, and then
Ist-2nd synchronizer sleeve in -2nd.
i?i
(3) Remove the mainshaft lock nut and count&shaft lock
nut.
34. REMOVAL OF COUNTER REAR BEARING 1.35. COUN-
TER OVERDRIVE GEAR
I
'a\+!
Pull off counter overdrive gear and ball bearing by using a
suitable puller.