Chrysler Conquest 1988 Service Manual page 862

14-68
E?L.sz
gg;;-
a=
FUEL (ECI) SYSTEM
pi?
-
ECI
System Components
:-
Gray
Injector
(Small)
Blue
Injector
(Large)
1lZ
* ECU
Injector
- Resistor
(Gray)
OlR012!
Caution
Check carefully. Other injectors may produce sound as
they operate even if the inj~ector under checking does not
operate.
Resistance between Terminals Measurement
(1) Disconnect the jnjector conne~ctor.
(2) Measure resistance between terminals.
Standard value: 2 - 3 U [at 20°C (68"F)I
(3) Install the injector connector.
Injection State inspection
(1) Remove the air intake pipe.
(2) Disconnect the high tension cable from the ignition coil.
Injector with Gray Connector Inspection
(3) Ob!sertiing through the air inlet of the injection mixer,
visually check injection state of the injector with gray
connector when the ignition switch is set-to ST position.
Judge the injector as normal unless the injection state is
very poor.
(4) Turn the ignition switch-to OFF and check the injector
nozzle for leaks.