Chrysler Conquest 1988 Service Manual page 1224

-
d
-
2
I- 102
AUTOMATIC TRANSMISSION
- Automatic Transmission Assembly
.,
r-4 ,.: '
JAT172
Servo release
JAT17:
c---' ,,.
\
'. \
JATl?E
32: lnstafl input shaft.
33. Before proceeding with installation of valve body assemtily, --
perform a final air check of-all assembled components. This
will ensure that you havenot overlocked tightening of any --
bolts or damaged any seals during assembly.
Air check pointy
34. Using an air gun w-ith a-tapered rubber tip, perform air
checks. I
35. Check that ~parkrng paw!, pm, sprrng and washer are _
assembled correctly.
36. Install rear extension. :-
Rear extension bolt: 20 - 25 Nm (14 - 18 ft.1bs.j
37. Install control valve body. Be sure manual valve IS In
alignment with selector -Tin. Tighten control valve body
attaching bolts
NOTE
Attaching bolts come inthree different lengths.
Control valve body attaching bolt:
5.4 - 7.4 Nm (4.0 - 5.4 ft.lbs.)
After installing- control valve body to transmission case,
make sure that manual lever can be moved to allWpositions.