Chrysler Conquest 1988 Service Manual page 1215

AUTOMATIC TRANSMISSION
- Automatic Transmission Assembly 21-93
JATI 3;
JATl3E
7. Using an air gun with a tapered rubber tip, check low and
reverse brake operation.
8. Install governor thrust washer and needle bearing.
9. Slide governor distributor assembly on output shaft from
front of shaft. Install shaft and governor distributor into
case, using care not to damage distributor rings.
IO. Install connecting drum with sprag by rotating drum
clockwise using a slight pressure and wobbling to align
plates with hub and sprag assembly. Connecting drum
should now be free to rotate clockwise only. This check will
verify that sprag is correctly installed and operative.
JATI
11. Install rear internal gear.