Chrysler Conquest 1988 Service Manual page 1231

AUTOMATIC TRANSMISSION
- Drum Support
21-109
JATO8;
JAT08E
ce
ring
JATO8
7
4. Install new O-ring and gasket on O.D. case.
5. Install drum support on O.D. case.
6. Insert the special tool into the bolt holes and perform the
centering.
7. Tighten drum support securing bolts to specified torque.
Drum support to O.D. case: 7 - 9 Nm (5.1 - 6.5 ft.lbs.)
INSPECTION
1. Inspect contacting surface of oil distributor and ring groove
areas for wear.
2. Measure clearance between seal ring and ring groove.
Standard clearance:
0.04 - 0.16 mm (.0016 - .0063 in.)
Replace if the clearance exc~eeds 0.16 mm i.0063 in.).
Of course, it is good practice to replace all seal rings during
an overhaul.