Chrysler Conquest 1988 Service Manual page 1192

21-70
AUTOMATIC TRANSMISSION
- On-vehicle Service
ON-VEHICLE SERVICE
NZlFA- -
The following parts can be servrced wrth the transmrssron on
the vehicle.
I. Control valve body assembly
'> Extension oil seal i-.
3. Parkinq components !.
==
4. Governor valve assembly
5. Inhibitor switch
6. Vacuum diaphragm and downshitt solenord
_~
Check and/or replace faulty parts as toliows;
JATOlt:
CONTROL VALVE BODY ASSEMBLY
1. Drain fluid by removing oil pan.
2. Remove dowshift solenoid and vacuum diaphragm and
rod. Be careful not to lose vacuum rod.
-
-
3. Remove seX@ei~ bolts and remove control valve body I~
assembly.
4. Disassemble, inspect and reassemble control valve body
assembly. Refer to page 21-120 for Control Valve Body. -T
5. Set manual shaft In Neutral, then align
manual
plate with-
groove in manual valve.-
.~
6. Install control valve body assembly and tighten seven bolts '1
to the specified torque.-
Control valve body mounting bolts:
5.4 - 7.4 Nm (4.0 - 5.4 ft.lbs.)
7. After instatalliiig control valve body to transmission case,
make sure that-control Icver can be moved to all position.
8. Install downshift solenoid and vacuum diaphragm and rod. -T
Make sure that vacuumdiaphragm rod does not interferes.:
with side plate of control valve.
9. Install new gasket and oil pan.
Oil pan bolts: 5 - 7 Nm (3.6 - 5.1 ft.lbs.)
IO. Secure clamps of governor tube and oil cooler tubes. _=
11. Refill with automatrc transmrssron fluid.