Chrysler Conquest 1988 Service Manual page 606

7-20
- . - - ~~~-
COOLING
- Water Pump
(!I!7 foW
hardness category
04lJoo25
INSPECTION
NO'IMDAH
DRIVE BELT FOR ALTERNATOR
A belt which has following defects should be replaced.
I
* Damaged, peeled or cracked surface.
@ Oily or greasy surface.
+ A belt worn to such an extent that it is in con-Erct with
l
bottom of V groove in pulley.
l
Worn or hardened rubber.
WATER PUMP
e Check each part for cracks, damage or wear, and replace
=
the water pump assembly if necessary.
l
Check the bearing for damage, abnormal noise and sluggish
rotation, and replace the water pump assembly if neces-
sary.
l
Check the seal-unit for leaks, and-replace the water pump
assembly if necessary.
-_
l
Check for water leakage. lfwater leaks from hole 'YA". seal
=
unit is leaking. Replace as an assembly.
SERVICE POINT OF INSTALLATION
N07MEAI
7. INSTALLATION OF WATER PUMP
Water pump installatio~n bolt size are different and-caution _
must be paid to ensure that they are properly installed.
I
No.
1
2
3
4
Hardness
category
(Head mark)
4T
4T
4T
4T
d x l mm (in.)
8x 23 (.31 x .90)
8x28(.31 x 1.10)
8 ~88 (.31 x 3.46)
8 x 78 (.31 x 3.07)
Torque
Nm (ft.lbs.1
12-15
(9- 10)