Chrysler Conquest 1988 Service Manual page 1060

3-42 REAR AXLE -
Differential Carrier
.
Y1153i
llY24:
(6) Place the~front bearing inner race in the gear carrier.
Z
(7) Drive the oil seal into the gear carrier front lip by using 1
the special tool.
(8) Apply specified grea& to the oil seal lip.
Specified grease:
Multipurpose grease SAE J310,
NLGI No. 2
With Oil Seal
(1) Apply a thin coat of -specified grease~to t& spline
coupling contacting surface of the washer before -z
installing drive pinion assembly.
Specified grease: MOPAR Multi-Mileage Lubricant
Part No. 2525035 or equivalent
(2) Install the~drive pinion assembly and Splin& coupling
with mating marks properly aligned, and tighten the
spline coupling mounting nut by using the special tools.
1
(3) Measure the drive pinion rotating torque (with oil seal)
to verify that the drive pinion rotating torque complies _
with the standard value.
Standard value: 40 - 50 Ncm (3.5 - 4.3 in.lbs.1
(4) Measure the spline coupling runout.
-
Standard value: 0.1 mm (.004 in.)
If the spline coupling runout exceeds the standard, .._
value, change the phase of the spline coupling and drive
pinion afterdisassembling the different@! carrier and L
measure the runout once again.
-_