Chrysler Conquest 1988 Service Manual page 1055

REAR AXLE
- Differential Carrier
3-37
DIFFERENTIAL CARRIER
N03lV- -
DISASSEMBLY AND REASSEMBLY
Inspection Before Disasse mbly
l
Final Drive Gear Backlash (Refer to P.3-34)
l
Drive Gear Runout (Refer to P. 3-34)
l
FinaLDrive Gear Tooth Contact (Refer to P. 3-35)
l
Spline Coupling Runout (Refer
to
P. 3-34)
55-65 Nm
1,. 1- r. . .
70 Nm
6
51 ft.lbs.
\
190-250 Nm
137-181 ftlbs.
SO-90.Nm
58-65 ftlbs.
55-65 Nm
40-47 ft.lbs.
4b-60 Nm
29-43 ftlbs.
I I
Disassembly steps
1. Rear supports
I)* 2. Vent plug
l
C 3. Cover
4. Bearing cap
4*
5. Differential case assembly
I)4
Final drive gear backlash adjustment
6. Side bearing adjusting spacer
7. Side bearing outer race
l
* I)* 8. Side bearing inner race
*I) ** 9. Drive gear
4*
IO. Spline coupling mounting nut (Self-locking
nut)
4*
11. Drive pinion
12. Drive pinion rear shim (for pinion height
adjustment)
I)4
Drive pinion preload adjustment
*c
Pinion height adjustment
13. Drive pinion spacer
14. Drive pinion front shim (for preload adjust-
ment)
4*
c*
15. Spline coupling
16. Drive pinion rear bearing inner race
17. Oil seal ;
18. Drive pinion front bearing inner race
*I) *(1 19. Drive pinion front bearing outer race
+* *+ 20. Drive pinion rear bearing outer race
21. Oil seal
22. Gear carrier '
NOTE
(1)
(2)
Reverse the disassembly procedures to reassemble.
(3)
+I): Refer to "Service Points of Disassembly".
(4)
I)*: Refer to "Service Points of Reassembly".
q
: Non-reusable parts