Chrysler Conquest 1988 Service Manual page 1074

17-6
REAR SUSPENSION
- Service Adjustment Procedures
SERVICE ADJUSTMENT PROCEDURES
;F;:L ALIGNMENT INSPECTION AND ADJUST-
Measure the wheel alignment--with the vehicle parked on level _
ground.
The rear suspen&rr and wh%ls should b& se-rviced to the 11
normal condltlon prior to measurement ot wheel alignment.
1. TOE-IN
(I) Measure the toe-in with a toe-in gauge:
Standard value: 0 t-2
mm (0 +-
.08
in.)
(2) If the toe-in is not wrthrn the standard value, adjust It by
moving the mounting bolts located on the crossmem- :,
ber side of the lower:-control arm. ~~
NOTE -'
Make the adjustment by moving the left and right bolts 1
equally.
Movement of one division on the scale will cause toe-in -z
variation of about 1 mm C.04 in.).
2. CAMBER
Measure the camber with-a camber/caster/kingpin gauge. ~-
(Refer to GROUP 2 FRCINT SUSPENSION - Service r:
Adiustment Procedures.)
Standard value: -075 + 30' (non-adjustable)
Difference between left and right wheels within 30'