Chrysler Conquest 1988 Service Manual page 1041

REAR AXLE - Drive Shaft
DRIVE SHAFT
REMOVAL AND INSTALLATION
3-23
N03JA- -
40--47ftJbs.
Removal steps
41) I)* 1, Drive shaft assembly
2. Circlip
I)+ 3.
Oil seal
NOTE
(I)
(2)
Reverse the removal, procedures to reinstall.
(3)
+*: Refer to "Service Points of Removal".
(4)
**: Refer to "Service Points of Installation".
q
: 'Non-reusable parts
SERVICE POINT OF REMOVAL
N03JBAA
1. REMOVAL OF DRIVE SHAFT ASSEMBLY
Pull the drive shaft out from the differential carrier by using
the special tools.
Caution
When pulling the drive shaft out from the differential
carrier, be careful that the spline part of the drive shaft
does not damage the oil seal.