Chrysler Conquest 1988 Service Manual page 1102

19-16
STEERING
- Steering Column and Shaft
Socket
Clamp
13K013
I
3
SERVICE POINTS OF REMOVAL
NWGBAI
1. REMOVAL OF HORN PAD
Remove the: h-orn pad and disconnect the horn cable =
connector. 1-1
-
2. REMOVAL OF STEERING WHEEL
Remove the:steering wheel by using the special tool. _
Caution
Do not hammer on the steering wheel to remove it,
or
else the collapsible mechanism may be damaged.
SERVICE POINTS OF INSTALLATION
NWGDAF
11. INSTALLATION OF STEERING SHAFT CLAMP
Align the cut of the joint socket with the bolt hole of the _
clamp.
9. INSTALLATION OF DASH PANEL COVER TO DASH -
PANEL BOLTS
When attaching the dash panel cover, apply specified
sealant around the bolt boles.
Specified sealant: MOPAR Lock N'Seal Adhesive Part
No. 4057989 or equivalent
2. INSTALLATION OF STEERING WHEEL
To install the steering wheel, hold the front wheels in the __
straight-ahead position, fit the three cancel pin2 into the
bottom holes jn the steering wheel, and tighten the .=
steering wheel lock nut to the specified torque.