Chrysler Conquest 1988 Service Manual page 654

.-
14-126
AUTOMATIC SPEED CONTROL (ASC) SYSTEM -
Procedures
Service Adjustment
SERVICE ADJUSTMENT PROCEDURES
NWFBBS
ACCELERATOR CABLE FREE PLAY INSPECTION
AND ADJUSTMENT
(I) Run the enqine until it reaches the specified idle speed.
(2) Turn the ignition switckto "OFF" to stop the engine.
-
(3) Check the accelerator cable for sharp bends.
(4) Check the inner cable that it has proper slackness. ~~
(5) If there is excessive or no slackness, adjust as follows.
1x1 Turn the ignition switch to "ON" for 15 seconds. (Do
not run Ihe engine.)
@ Loosen the adjustingcnut so that the throttle lever is
free.
@ Turn the accelerator adjusting nut to the point where I
the thro-ttle lever just-starts moving, then back off l/2 ~~
turn and secure the lock nut.
(6) Confirm that the idle position switch touches to the stopper
after the idle speed con-trol adjustment.
SPEED CONTROL CABLE ADJUSTMENT
N14FAAA
(1) Adjust the play of accelerator cable.
~~
(2) Slide the speed control cable in the direction of
the
arrow
up to a point just beforethe accelerator pedal
begins to
move, and secure the speed control cable by inserting a ~.
clip.
(3) Check to ensure-that the play of speed control cable is up to
standard value.
Standard value: 0 - 3 mm (0 - .I in.)
NOTE
If
the
play
adjtistment~is
incorrect, either an increase of idle
speed or lack of speed control in the high speed range will
result.