Chrysler Conquest 1988 Service Manual page 1120

19-34
STEERING - Oil Pump
Direct round edge to the cam ring
Vane
13K562 13c217
Punched mark
Dowel pins
13wo3c I
9. INSTALLATION OF ROTOR
(1) Mount the rotor ontothe shaft.
(2) When installing the rotor, the countersunk part (shown
in the illustration) should face the pump cover side.
8. INSTALLATION OF SNAP RING
(1) Install the snap ring.
(2) Lift the rotor-and check to be sure that the snap ring has
entered--the coun.tersunk part.
7. INSTALLATION OF VANE
s?Es
(1) Apply the specified automatic transmis.sion fluid to the z :
vanes. -L-
Specified fluid: MOPAR DEXRON or DEXRON II
Automatic Transmission Fluid Part
No. 3549660 or 4131509, or equiva-
lent
(2) Install the vanes on the rotor paying close attention to
the installation direction.
6. INSTALLATION OF CAM RING
Install the cam ring with its punched mark facing the pump :
body and its dowel holes aligned with the dowel pins on the
pump body.