Chrysler Conquest 1988 Service Manual page 376

__ ME ~; _
STARTING SYSTEM - General Information
STARTING SYSTEM
LL
NOEFAAF
s@-
e
- i
GENERAL INFORMATION
zzF.
Starting system circuit rncludes a battery, starter motor, magnet
swmh,
lgnltlon switch, inhibitor switch
BET-
(vehicle with automatrc transaxle only), connection wires and battery cable.
E;-
=
L
When ignition switch is turned to "START" position, current flows to energize solenoid windings ot starter
1
motor&-a r_esulLsolen@d plunger and clutch shift lever operate to cause clutch pinion to engage with ring
E
gear. At the same time, magnet switch contacts close to crank starters motor.
~-
Running clutch pinion gear overruns to prevent damage that could be caused by overrunnlng ert starter -
armature when engine is started Immediately. When engine is started, ignition switch must be turn@ back. tp _
"ON" position to prevent damage to starter motor.
Inhibitor switch
-
0 0
1 Ignition switch
I