Chrysler Conquest 1988 Service Manual page 732

ENGINE
- Timing Chain Train
Chain
a,u,ide,
bd Plated link
5ENiXli
_--
<=, -$$%I chain e Timing chain side
when sprocket
IS installed boil
pump drive gear
Right side
when sprocket
is bstalled to
left silent shaft
Left side
5EijQQ4
SERVICE POINTS OF REMOVAL
NOSWESU
21. REMOVAL OF CAMSHAFT SPROCKET / 22. TIMING
CHAIN / 23. CRANKSHAFT SPROCKET
Remove the tlm1r-q chain combined with camshaft~sprocket
and crankshaft sprocket.
-
INSPECTION
NOSWCAA
l
Check the tlmxq chain for roller play, wear, damage or
disconnected links.
-
Replace if tiessary.
@ Check the tensroner and chain guide rubber shoe for wear ~~
or damase.
Replace if necessary. Y
SERVICE POINTS OF INSTALLATION
NOSWDAA
18. INSTALLATION OF TENSIONER SPRING / 17. RUBBER
SHEET / 16. TENSIONER SLEEVE
Install tensioner spring sleeve and rubber sheet to oil pump, -
and then install the oil pump.
22. INSTALLATION OF TIMING CHAIN
(1) Turn crafiksfiaft until piston of No.1 cylinder is at top
dead
center.
_
(2) Line up plated links of timing chain and timinsmarks on ~;
sprockets as chain and sprockets are-assembled.
(3) While sli-ding crankshaft sprocket onto ~wnkshaft, ;
install chain and sprocket. Place cams&&sprocket on
sprocket holder,
14. INSTALLATION OF LEFT SILENT SHAFT SPROCKET
(1) Assemble silent shaft sprockets to chain "B". Make .
sure that timing mar&s are in alignment with plated
links. I
-zz
(2) Use care~hot to confuse right and left sprockets, as they
are installed in opposite directions.
i