Table of Contents
Advertisement
Note:
When starting the A/D converter by an external trigger or an internal timer, set the input value of
the internal timer and the external trigger only in inactive state.
For setting STS1 and STS0, set in the state of ADTG=1 input and internal timer (PPG1) = 0 output.
[bit9] STRT: start
8/10-bit A/D converter is started by software.
•
Set this bit by writing "1" to start A/D conversion.
•
For restarting, write this bit again.
•
When stop mode is set, operation cannot be restarted by an operational function.
•
This bit is initialized to "0" at reset.
•
The byte/words instructions read "1".
•
The read-modify-write type instructions read "0".
Note:
Do not execute forced stop and software start simultaneously. (BUSY = 0, STRT = 1)
[bit8] Reserved
In write operations, write "0".
CHAPTER 17 8/10-BIT A/D CONVERTER
365
Advertisement
Table of Contents
