Fujitsu MB90480 Series Hardware Manual page 349

Notes:
• Do not set these bits to "10
• To set these bits to "01
"01 ". It is recommended that the PEN0 bit and the corresponding PEN1 bit be set to "11
B
"00 " at the same time.
B
• To set these bits to "11
PEN0/PEN1 bits to "11
[bit8] reserved bit
This bit is reserved. When setting PPGC1/PPGC3/PPGC5, always set this bit to "1".
".
B
", do not set the PEN0 bit of PPGC0 and the PEN1 bit of PPGC1 to
B
", rewrite the contents of PPGC0/PPGC1 by word transfer and set the
B
" or "00 " at the same time.
B B
CHAPTER 15 8/16-BIT PPG TIMER
" or
B
327