Ipx Configuration - 3Com 7757 Configuration Manual

138 C 17: IPX C
HAPTER

IPX Configuration

Configuring IPX
Basic IPX Configuration
Configuring IPX Routing
ONFIGURATION
directly connected to them. However, you cannot use such information directly.
Instead, the information is collected by the SAP agents of the switches on the
networks and saved in their server information tables.
Table 83 Configure IPX
Configuration task
Basic IPX configuration
IPX routing configuration
IPX RIP configuration
IPX SAP configuration
IPX forwarding-related
configuration
Table 84 Basic IPX configuration
Operation
Enter system view
Enable IPX
Enter VLAN interface view
Configure an IPX network
number for the VLAN
interface
n
After the undo ipx enable command is executed, the IPX configurations are
■
cannot be recovered with the ipx enable command.
After IPX is enabled, you must assign a network number to a VLAN interface to
■
enable IPX on this VLAN interface. One network number can be assigned to
only one VLAN interface.
If the IPX network number of a VLAN interface is deleted, the IPX configuration
■
and static routing information of this VLAN interface will be deleted at the
same time.
Configuring IPX static routes
Table 85 Configure IPX static routes
Operation
Enter system view
Description Detailed configuration
Required
138
Required
138
Required
Required
Required
144
Command
system-view
ipx enable
interface Vlan-interface vlan-id -
ipx network network
Command
system-view
"Basic IPX Configuration" on page
"Configuring IPX Routing" on page
"Configuring IPX RIP" on page 139
"Configuring IPX SAP" on page 141
"Configuring IPX forwarding" on page
Description
-
Required
IPX is disabled by default
Required
By default, the system does
not assign network numbers
to VLAN interface. That is, IPX
is disabled on all the VLAN
interfaces
Description
-