List Of Sms Commands - Sierra Wireless AirLink RV50 Series User Manual

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Command
Note: Some responses start with "reply from [device name]:" However, this feature is currently unavailable for the Enable
and Provision commands.
[prefix]enable <value>
[prefix]status
[prefix]reset
[prefix]relay x y
[prefix]relay x ?
[prefix]gps
Rev 1 Dec. 17

List of SMS Commands

Action
Enable/disable the device(s)
being managed by ALMS.
None
Resets the device 30
seconds after the first
response message is sent.
Sets the I/O relay to the
desired setting.
Queries the current value of
the I/O relay.
The device replies with its
current location.
472
Result
"AVMS enable set to status:" <value>
<value>=0 Disable
<value>=1 MSCI
<value>=2 LWM2M
<value>=3 Try LWM2M, Fallback to MSCI
status IP
[Network IP] [Network Status]:
[technology type] RSS signaled
Lat = [Latitude]
Long = [Longitude]
Time = [hh:mm:ss]
Note: Location Service must be enabled to
obtain Lat and Long data.
First message: Reset in 30 seconds
Second message: Status message when
back up.
relay x set to y
x can be 1
y can be 0 or 1 (Off or Drive active low)
relay x set at y
x can be 1
y is the current value of the I/O relay. (0 =
Off; 1 = Drive active low)
The device sends a link to a map showing its
location. You can copy the link into a browser
to view the location, or if the SMS is sent
from a smartphone, you can click the link to
view the map.
Note: Location Service must be enabled.
41111088