Sierra Wireless AirLink RV50 Series User Manual page 156

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Rev 1 Dec. 17
4. Select the desired protocol (see
· TCP
· UDP
· TCP & UDP
5. Enter the IP address of the computer you want to forward data to.
To forward a port to a local ALEOS Service, set the Host IP to 127.0.0.1.
6. In the Private Start Port field, enter the starting port number for the range of
ports on the destination computer that you want to forward data to.
7. If you want to add another range, click Add More to display a new rule line.
8. Click Apply.
The Port Forwarding screen allows for 24 port forwarding rules.
9. Optional—If you need additional port forwarding rules, click Extended Port
Forwarding on the left menu, and continue adding rules, up to a total over
both screens of 48.
Figure 7-5: ACEmanager: Security > Extended Port Forwarding
10. Reboot.
You do not need to reboot immediately, if you have additional changes to
make, but port forwarding does not take effect until the device is rebooted.
Note: Sierra Wireless recommends that the total number of port forwardings be fewer than
1000 ports, including single port forwarding and port forwarding within a range.
Field Description
Port Forwarding Enables port forwarding rules. Options are Enable and Disable
(default).
Public Start Port Port on the public network or starting port on the public network
for a range of ports.
•
156
Protocol on page 157):
Supported values: 1–65535
(Recommended values: greater than 1024)
41111088