Sierra Wireless AirLink RV50 Series User Manual page 301

Table 13-1: I/O: Current State
Command
Digital Input
Number
Value
Pulse Count 1
Analog Input
Number
Value (Volts)
Transformed Analog
Rev 1 Dec. 17
Description
Displays the number of digital inputs. The corresponding hardware pins are:
Digital Input
1 Pin 4 on Power connector
Displays the current value for the digital input:
0 —Low
•
1 —High
•
You can also use an AT command to read these values. See
page 464*DIGITALIN[n]?
The pulse count increments when the input value changes from high to low.
Note: To reset the pulse count to zero, reset the device to the factory defaults.
Displays the number of analog inputs. The corresponding hardware pins are:
Analog Input
1 Pin 4 on Power connector
Shows the current state of the analog input
The analog inputs report the voltage in volts. Range is 0–30 volts.
You can also use an AT command to read these values. See
page 464.
The analog input expressed in the configured units. See
page 304.
301
Corresponding hardware pin
on page 464.
Corresponding hardware pin
I/O Configuration
*DIGITALIN[n]? on
*ANALOGIN[n]? on
Transformed Analog on
41111088