Sierra Wireless AirLink RV50 Series User Manual page 457

Table D-10: Serial AT Commands
Command
S60
S82
S83
*SERIALLEDDISPLAY
TCPS
TCPT
Rev 1 Dec. 17
Description
Query or set the Telnet Client Echo Mode.
ATS60? to query
ATS60=n to set
n=0—No Echo
•
n=1—Local Echo (default)
•
n=2—Remote Echo
•
Query or set UDP auto answer.
ATS82? to query
ATS82=n to set
n=0—Disable
•
n=1—Enable
•
Query or set the UDP auto answer idle timeout. If no data is sent or received before
the timeout occurs, the current UDP session is terminated. While a session is active,
packets from other IP addresses are discarded (unless *UALL is set).
ATS83? to query
ATS83=n to set
n=0—No idle timeout (default)
•
n=1–255—Timeout in seconds
•
Note: This AT command only takes effect if the UDP Auto Answer (S82) is set to
Enable.
Query or set whether or not the Activity LED on the AirLink gateway indicates traffic
on the selected serial port.
AT*SERIALLEDDISPLAY? to query
AT*SERIALLEDDISPLAY=n to set
n=0—LED display of serial traffic disabled (default)
•
n=1—LED display of serial traffic enabled
•
For a description of the Activity LED when this parameter is enabled, see
page 286.
Query or set the TCP connection timeout (TCPS) units. If there is no traffic through
the TCP connection for the specified interval, the connection is terminated.
AT*TCPS? to query
AT*TCPS=n to set
n=0—minutes
•
n=1—seconds
•
Query or set the interval to terminate a TCP connection when there is no traffic. This
value affects only the TCP connection in TCP PAD mode.
AT*TCPT? to query
AT*TCPT=n to set
n=0–255
•
457
AT Commands
Display on
41111088