Sierra Wireless AirLink RV50 Series User Manual page 245

Table 9-4: Location: Local/Streaming — Local IP Report
Field
Local Report Type
Starting Destination
Port
Number of Extra
Destination Ports
Rev 1 Dec. 17
Description
If the Location Reports Format is Predefined, sets one of the following Local Report types:
RAP
Location Data—RAP location report that contains only location data
•
Location+Date—RAP location report that contains location data with the UTC time
•
and date (default)
Location+Date+RF—RAP location report that contains location data, the UTC time
•
and date, and radio frequency information for the cellular connection
Location+Date+RF+EIO—RAP location report that contains location data, the UTC
•
time and date, radio frequency information for the cellular connection, and the current
I/O state
NMEA
NMEA GGA+VTG—NMEA location report that contains fix information, vector track,
•
and speed over ground
NMEA GGA+VTG+RMC—NMEA location report that contains fix information, vector
•
track, speed over ground, and recommended minimum location data
NMEA GGA+VTG+RMC+GSA+GSV—NMEA location report that contains fix infor-
•
mation, vector track, speed over ground, the recommended minimum location data,
overall satellite data, and detailed satellite data
TAIP
TAIP data—TAIP location report that contains position and velocity
•
Compact TAIP data—TAIP location report that contains the compact position
•
TAIP LN report—TAIP location report that contains a long navigation message
•
TAIP TM report—TAIP location report that contains the time and date.
•
Note: You can also use an AT Command to set this value. For more information, see
*PPLATSR on page 450.
Note: Local IP Report does not have an option for Xora reports.
The primary port that reports are sent to
The Local IP report source port is 17335. This is not configurable.
You can send the report to up to 7 additional consecutive ports. For example, if the starting
port is 12351 and you set this field to 5, reports are sent to ports 12351, 12352, 12353,
12354, 12355, and 12356.
The default is 0, which means only the starting port is used.
You can also use an AT Command to set this value. For more information, see
*PPLATSEXTRA on page 450.
245
Location
41111088