ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-4: WAN / Cellular AT Commands
Command
*IPPINGADDR
*MONITORTYPE
*MSNOSERVICETOUT
*MSSECONDARYTOUT
Rev 1 Dec. 17
Query or set the ping monitor IP address or FQDN for an interface when the ping
monitor test interval (*IPPING) is set.
AT*IPPINGADDR?<interface> to query
interface=1—Cellular network
•
interface=2—Wi-Fi network
•
interface=3—Ethernet WAN network
•
AT*IPPINGADDR=<interface>,d.d.d.d or n to set
interface=1—Cellular network
•
interface=2—Wi-Fi network
•
interface=3—Ethernet WAN network
•
d.d.d.d=IP address
•
n=domain name
•
If no interface is specified, the command applies to the cellular network.
Note: AT*IPPING must to be set to a value other than 0 to enable pinging.
Query or set the monitor type that is enabled on each interface.
AT*MONITORTYPE?<interface> to query
interface=1—Cellular network
•
interface=2—Wi-Fi network
•
interface=3—Ethernet WAN network
•
AT*MONITORTYPE=<interface>,n to set
interface=1—Cellular network
•
interface=2—Wi-Fi network
•
interface=3—Ethernet WAN network
•
n=0—Disable
•
n=1—Enable
•
If no interface is specified, the command applies to the cellular network.
Query or set the time in minute before switching to the inactive SIM card if there is no
longer service on the current SIM card.
AT*MSNOSERVICETOUT? to query
AT*MSNOSERVICETOUT=<n> to set
<n>=10–255
•
<n>=0—feature is disabled (default)
•
Query or set the time in minute before switching to the primary SIM card if the
gateway is connected to the network using the secondary SIM card.
AT*MSSECONDARYTOUT? to query
AT*MSSECONDARYTOUT=<n> to set
<n>=10–255
•
<n>=0—feature is disabled (default)
•
416
Description
41111088