Ethernet; Static Configuration - Sierra Wireless AirLink RV50 Series User Manual

Field Description
Test Interval The amount of time between tests of the cellular connection. Available range is:
(minutes)
•
Most applications work well with an interval of 15 to 60 minutes.
Monitor Type Determines the type of test run on the interface to diagnose its ability to provide end-to-end
connectivity for this interface. Options are:
•
•
•
Note: Using pings to monitor the interface may accrue data charges. Each individual ping is approx-
imately 98 bytes (196 bytes for ping sent plus ping response).
Ping Test IP Enter the IP address to ping.
Address
Time Between Time between individual pings
Pings
Available range is:
(seconds)
•
Rev 1 Dec. 17
2–255 minutes (Default is 15.)
Disabled—No end-to-end diagnostic runs and the service state cannot be verified. Therefore it
is assumed that this interface provides service if an IP is assigned.
Traffic Monitor—A ping test is only performed if there is no traffic during the configured interval.
Ping Test—A ping is sent at the end of the test interval regardless of whether or not there has
been any traffic during the interval (i.e. if the interface receives ingress traffic regularly, no
additional traffic is generated by the gateway).
5–20 seconds (Default is 20.)
If the first ping fails, the AirLink gateway sends four additional pings at the configured interval. If
all five pings fail, the AirLink gateway declares the service state as "Not Established" and
attempts to switch to another interface according to the
ration, and interface availability.
If this field is set to 10 and the test is started and fails, the interface does not provide service for
a total of 50 seconds.

Ethernet

Static Configuration

Before configuring the Ethernet WAN mode, go to LAN > Ethernet and ensure
that the Ethernet port is set to WAN.
87
WAN/Cellular Configuration
Interface Priority (see page 65) configu-
41111088