Sierra Wireless AirLink RV50 Series User Manual page 233

Table 9-2: Location: Servers 1 – 4
Field
Enable Digital Input
Event
Report Type
Location Report
Format
Rev 1 Dec. 17
Description
A location report is sent if the configured digital input changes. For example, this could be
used to trigger a report being sent when an emergency light or siren is turned on or off, or
when a door is opened or closed. The location data in the report informs you of where the
event took place.
Options are:
Disable (default)
•
Enable
•
Note: If you are using one of the RAP location report types (see
page 234) the location report triggered by this feature includes:
A marker to indicate that it was triggered by a change in status of the configured digital
•
input
The standard location information for the configured report type
•
For more information, refer to the RAP Protocol Guide.
If you are not using a RAP location report, a standard report is sent.
You can also use an AT Command to set this value. For more information, see
*PPINPUTEVT on page 449.
Configures the format of location reports.
Options are:
Predefined (default)—When selected, the reports contain TAIP and NMEA GPS strings.
•
If Predefined is selected, you can select Location Report Type. See
Type on page 234.
User-defined NMEA—You can enable or disable GGA, RMC, VTG, GSA, and GSV
•
sentences individually.
233
Location
Location Report Type on
Location Report
41111088