Sierra Wireless AirLink RV50 Series User Manual page 452

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-9: Location AT Commands
Command
*PPTAIPID
*PPTIME
*PP2TIME
*PP3TIME
*PP4TIME
*PPTCPPOLL
*PPTSV
*PP2TSV
*PP3TSV
*PP4TSV
Rev 1 Dec. 17
Description
Query or set the four character alphanumeric TAIP ID.
AT*PPTAIPID? to query
AT*PPTAIPID=nnnn to set
nnnn=alphnumeric characters
•
Query or set the Location report time interval (in seconds).
AT*PP[Server number if other than server 1]TIME? to query
AT*PP[Server number if other than server 1]TIME=n to set
n=0–65535 seconds
•
Note: Your cellular Mobile Network Operator may impose a minimum transmit time.
See also *PPMINTIME, *PPTSV, +CTA.
Note: A report time of less than 30 seconds may keep an RF link up continuously, tying
up an RF resource to transfer small amounts of data. Generally, the RF channel is
released and goes dormant in 10–20 seconds if no data is sent or received.
Query or set the port to listen on for TCP Location report polling.
Note: The request to this port needs to come from the same IP address in
page 449 and uses the report type configured for server 1.
AT*PPTCPPOLL? to query
AT*PPTCPPOLL=n to set
n=0—Disabled
•
n=1–65535 (default is 9494)
•
Query or set the time interval in minutes that the device sends in reports when it is
stationary (Stationary vehicle timer).
AT*PP[Server number if other than server 1]TSV? to query
AT*PP[Server number if other than server 1]TSV=n to set
n=0—Disabled
•
n=1–255 minutes
•
For example, if *PPTIME=10, the device sends Location reports at least once every 10
seconds while it is moving; however, once it stops moving, it slows the reports down to
this *PPTSV value.
Note: In order for the PPTSV (Stationary Vehicle timer) to take effect, the PPTIME
value must be set to a value greater than 0 and less than the PPTSV value. The
PPTSV timer checks for vehicle movement at the PPTIME interval, so if PPTIME is
disabled, then PPTSV will also be disabled.
452
*PPIP on
41111088