Sierra Wireless AirLink RV50 Series User Manual page 411

Table D-4: WAN / Cellular AT Commands
Command
*CLIENT_PPP_AUTH
*CLIENT_PPP_AUTHSIM1
Rev 1 Dec. 17
Query or set the Force Network Authentication mode.
AT*CLIENT_PPP_AUTH? to query
AT*CLIENT_PPP_AUTH=n to set
n=0—None
•
n=1—PAP
•
n=2—CHAP
•
Examples:
*ATCLIENT_PPP_AUTH?
1
OK
*ATCLIENT_PPP_AUTH=2
OK
If this command is used with an AirLink RV50 Series gateway, the query or set
applies to the Active SIM. Use
*CLIENT_PPP_AUTHSIM2
installed in.
Query or set the Force Network Authentication mode for the SIM card in Slot 1 (upper
slot).
AT*CLIENT_PPP_AUTHSIM1? to query
AT*CLIENT_PPP_AUTHSIM1=n to set
n=0—None
•
n=1—PAP
•
n=2—CHAP
•
Examples:
*ATCLIENT_PPP_AUTHSIM1?
1
OK
*ATCLIENT_PPP_AUTHSIM1=2
OK
411
Description
*CLIENT_PPP_AUTHSIM1
to query or set a specific SIM card, based on the slot it is
AT Commands
or
41111088