Table D-9: Location AT Commands
Command
*PPGPSR
*PP2GPSR
*PP3GPSR
*PP4GPSR
*PPINPUTEVT
*PP2INPUTEVT
*PP3INPUTEVT
*PP4INPUTEVT
*PPIP
*PP2IP
*PP3IP
*PP4IP
*PPLATS
Rev 1 Dec. 17
Description
Query or set the Location report type.
AT*PP[Server number if other than server 1]GPSR? to query
AT*PP[Server number if other than server 1]GPSR=n to set
RAP reports:
n=0—Use legacy reports specified in *MF value. Note: Must also have
•
*PPDEVID=0.
n=11—Standard Location Report
•
n=12—Standard Location Report + UTC Date
•
n=13—Standard Location Report + UTC Date + RF data
•
n=14—Standard Location report + Location + Date + RF + EIO
•
Xora reports
n=D0—Xora
•
NMEA reports
n=E0—GGA and VTG NMEA reports
•
n=E1—GGA, VTG and RMC NMEA reports
•
n=E2—GGA, VTG, RMC, GSA and GSV NMEA reports
•
TAIP reports
n=F0—TAIP data—TAIP Location report that contains position and velocity
•
n=F1—TAIP Location report that contains the compact position
•
n=F2—TAIP LN report—TAIP Location report that contains a long navigation
•
message
n=F3—TAIP TM report—TAIP Location report that contains the time and date
•
Query or set ability to send a special report for digital input changes.
AT*PP[Server number if other than server 1]INPUTEVT? to query
AT*PP[Server number if other than server 1]INPUTEVT=n to set
n=0—Disable
•
n=1—Enable
•
Query or set the IP address where Location reports are sent. See also
page 451.
AT*PP[Server number if other than server 1]IP? to query
AT*PP[Server number if other than server 1]IP=d.d.d.d to set
d.d.d.d=IP address
•
Example:
AT*PPIP=192.100.100.100
Query or set the local reporting interval (in seconds).
AT*PPLATS? to query
AT*PPLATS=n to set
n=0—Disable (default)
•
n=1–255 (seconds)
•
449
AT Commands
*PPPORT
on
41111088