Gateway Only - Sierra Wireless AirLink RV50 Series User Manual

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Rev 1 Dec. 17
3. Enter the desired password in the ALEOS Command Password field or leave
the field as is to use the default password.
The password you enter can be any alphanumeric string between 1 and 255
characters long.
For more information see
Note: If all the SMS commands you send in Control Only mode are from a trusted number,
you do not need to include a password when you send the command.
4. If desired, change the ALEOS Command Prefix or use the default prefix, &&&.
Note: The maximum length of the ALEOS Command Prefix is 3 characters (alphanumeric
or special characters). If you leave the ALEOS Command Prefix field blank, no prefix is
required when you send the SMS command. The option to omit the prefix is only available
in Control Only mode.
5. If desired, configure SMS Security options (see
SMS Wakeup (see
SMS > Advanced on page 205).
6. Click Apply.
For information on the message format, see
AirLink Gateway on page 188.

Gateway Only

In Gateway Only mode you can send and receive SMS gateway messages
through the AirLink gateway to a local device. SMS messages received by the
AirLink gateway (inbound) are sent on to the configured local device. Messages
sent by the local device to a configured port on the AirLink gateway are sent out
as SMSs (outbound) to a remote destination. Essentially, the AirLink gateway
sends SMS messages between the cellular radio and the connected device.
In Gateway Only mode, you can also send SMS commands provided you include
a password. For more information, see
Gateway on page 188.
To configure ALEOS for Gateway Only mode and format a Gateway message:
1. In ACEmanager, go to Services > SMS.
192
SMS Password Security
SMS Wakeup on page 200), and Advanced options (see
Sending SMS Commands to an
Sending SMS Commands to an AirLink
on page 203.
SMS Security on page 201),
41111088