Sierra Wireless AirLink RV50 Series User Manual page 429

Table D-5: LAN AT Commands
Command
*HOSTPEERIP
*HOSTPRIVIP
*HOSTPRIVMODE
*HOSTPW
*HOSTUID
*USBDEVICE
Rev 1 Dec. 17
Description
Query or set the IP address of the device's Ethernet port. By default this is 192.168.13.31.
Note: Any connected LAN device can access this IP addresses, whether using a private or
public IP address. This IP address must be in the same subnet as the Ethernet DHCP pool.
AT*HOSTPEERIP? to query
AT*HOSTPEERIP=d.d.d.d to set
d.d.d.d=local or peer IP address of the device
•
Query or set the starting IP for the Ethernet DHCP pool.
AT*HOSTPRIVIP? to query
AT*HOSTPRIVIP=d.d.d.d to set
d.d.d.d=IP Address
•
Activate IP passthrough to the selected interface or query the IP passthrough setting.
AT*HOSTPRIVMODE? to query
AT*HOSTPRIMODE=n to activate IP Passthrough to the selected interface
n=0— IP passthrough on Ethernet
•
n=1— IP passthrough is disabled
•
n=2—IP passthrough on USB
•
n=3— IP passthrough on main serial port using DUN
•
Query or set the host password for PPPoE only. (It does not set the password for PPP/DUN.)
AT*HOSTPW? to query
AT*HOSTPW=PASSWORD to set
Note: PASSWORD cannot be "password".
Query or set the Host user ID for PPPoE only. (It does not set the user ID for PPP/DUN.)
AT*HOSTUID? to query
AT*HOSTUID=USER ID to set (up to 64 bytes)
Note: USER ID cannot be "user".
Query or set the startup mode for the USB port.
AT*USBDEVICE? to query
AT*USBDEVICE=n to set
n=0— USB Serial
•
n=1— USBNET
•
n=2— Disabled
•
429
AT Commands
41111088