Sierra Wireless AirLink RV50 Series User Manual page 232

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table 9-2: Location: Servers 1 – 4
Field
Stationary Vehicle
Timer (minutes)
Maximum Speed
Event Report (km/h)
Send Stationary
Vehicle Event in
Seconds
Rev 1 Dec. 17
Description
You can use this field if you want to receive less frequent reports when the vehicle is
stationary. A location report is sent every x minutes the vehicle (or device) is stationary,
where x is the value configured in this field. When the vehicle is stationary, this value
overrides the value configured in the Report Interval Time field.
Options are:
1–255
•
0 = Disables location reporting based on a vehicle being stationary (default)
•
You can also use an AT Command to set this value. For more information, see
page 452.
A location report is sent if the speed (in kilometers per hour) configured in this field is
exceeded, and again when the speed goes back down below the configured value.
0 = Disable (default)
•
1–255
•
Note: If you are using one of the RAP location report types (see
page 234) the location report triggered by this feature includes:
A marker to indicate that it was triggered by the configured speed being exceeded and
•
when the speed is goes back down below the configured value.
The standard location information for the configured report type
•
For more information, refer to the RAP Protocol Guide.
If you are not using a RAP location report, a standard report is sent.
A location report is sent if the vehicle (or device) has been in one location for more than the
specified time (in seconds) and again when the vehicle (or device) moves from that
location. Options are:
1–255
•
0 = Disables sending location reports based on a vehicle being stationary (default)
•
Note: If you are using one of the RAP location report types (see
page 234) the location report triggered by this feature includes:
A marker to indicate that it was triggered by the vehicle either being stationary or
•
starting to move again
The standard location information for the configured report type
•
For more information, refer to the RAP Protocol Guide.
If you are not using a RAP location report, a standard report is sent.
You can configure Stationary Vehicle Event in Seconds and Stationary Vehicle Timer
together to receive a special report when the device is stationary longer than x seconds, a
normal report every x minutes it is stationary (instead of the Report Interval Time) and a
special report when the vehicle begins moving again.
232
*PPTSV on
Location Report Type on
Location Report Type on
41111088