Configuring A Pppoe Connection In Windows 7 - Sierra Wireless AirLink RV50 Series User Manual

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Rev 1 Dec. 17
3. If you want to use authenticated PPPoE:
a. Go to LAN > PPPoE, and in the Host Authentication Mode field, select
PAP and CHAP.
b. In the Host User ID, enter a user ID for the PPPoE connection.
c. In the Host Password field, enter a password for the PPPoE to
connection.
4. Click Apply.
5. Reboot the gateway.
Tip: If you leave Host User ID and Host Password blank, any computer or device can
connect to the AirLink gateway using PPPoE.
Note: ACEmanager shows the existing value for the PPPoE password as stars (****).
Optional: Configure the Device Name
1. In ACEmanager, go to Services > Dynamic DNS.
2. In the Service field, select IP Manager.
3. Under Dynamic IP, enter a name in the Device Name field, such as AirLink
gateway or the ESN. The name can be up to 20 characters long.
The name you choose for Device Name does not affect the connection, but
may need to be configured in PPPoE settings for the router, device, or com-
puter you connect to your AirLink gateway.

Configuring a PPPoE Connection in Windows 7

1. In Windows 7, go to Start > Control Panel.
Figure 5-12: Windows 7: Control Panel
126 41111088