Status - Sierra Wireless AirLink RV50 Series User Manual

Table D-1: Device Update AT Commands
Command
*RMUPDATE
*TPLUPDATE
Table D-2: Status AT Commands
Command
*BAND?
*CELLINFO?
*CELLINFO2?
Rev 1 Dec. 17
Description
This AT command remotely updates only the radio module firmware.
The radio module firmware file must be on an ftp server, and the file name must have the suffix
.bin
The command parameters are:
AT*RMUPDATE=<FTP Server IP>,<user>,<password>,<RM filename>
Where:
<FTP Server IP> is the IP address of the FTP server
•
<user> is the user name used to access the FTP server
•
<password> is the password used to access the FTP server
•
<RM filename> is the name of the radio module firmware.
•
Example:
AT*RMUPDATE=192.168.17.111,MyUserName,password,MC7700_GCA001_35295.bin
This AT command updates the template (configuration file) remotely.
The template file must be accessible on an FTP server.
The command parameters are:
AT*TPLUPDATE=<Server_IP>,<USER_NAME>,<PASSWORD>,<FILE_NAME>
where:
SERVER_IP is the IP address of the FTP server.
•
USER_NAME is the user name used to access the FTP server.
•
PASSWORD is the password used to access the FTP server.
•
FILE_NAME is the name of the template file on the FTP server that you want to apply to
•
the AirLink gateway. The template file must be stored on the FTP User_Name home, not
in a sub-folder.
Example:
AT*TPLUPDATE=192.168.17.111,MyUserName,MyPassword,NewTemplate.xml
When the template is successfully applied, the message displayed is:
Template applied successfully
OK
Note: Configure the FTP server:
As passive mode (not active mode)
•
To listen to port 21
•

Status

Description
Query the current radio module band.
To set or query the setting for RF band range or technology, see
Query cellular connection information.
Query in depth cell information.
401
AT Commands
!BAND on page 409.
41111088