Sierra Wireless AirLink RV50 Series User Manual page 114

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Field
General
Device IP
Starting IP
Ending IP
DHCP network mask
DHCP Mode
Ethernet Port Configuration
Port Number
State
Rev 1 Dec. 17
Description
The Ethernet IP address of the AirLink gateway. By default this is set to 192.168.13.31.
Ethernet DHCP pool starting IP address
Default is 192.168.13.100.
Note: If only one computer or device is connected directly to the Ethernet port, this is the
IP address it is assigned.
The ending IP address for the Ethernet interface DHCP pool
Default is 192.168.13.150.
The Netmask given to any Ethernet DHCP client
Default is 255.255.255.0.
Determines how DHCP operates on the Ethernet interface
Options are:
Server—The AirLink gateway acts as a DHCP server for all Ethernet connections.
•
Disable—The AirLink gateway acts as neither a DHCP server or client. All devices
•
connected to the AirLink gateway must have a static LAN IP or use PPPoE.
Auto—When the gateway is powered on or reboots, it attempts to determine if a
DHCP server is present on the Ethernet network. If a DHCP server is found, the
gateway obtains an IP address and it can communicate with AirLink Management
Service (ALMS). If a DHCP server is not found, the gateway becomes a DHCP
server. (default)
When using Auto DHCP, set the Ethernet port as Auto or LAN (not WAN). See
on page 115.
For a full-featured auto DHCP, see
Most of the time you can leave this field set to the default value.
Ethernet Port number
The number of Ethernet ports available varies depending on the gateway.
State of the Ethernet Port (Enable or Disable)
Note: When the port is disabled, the device ignores any physical connection to the
Ethernet port.
114
Ethernet WAN Auto Mode.
Mode
41111088