Sierra Wireless AirLink RV50 Series User Manual page 303

Field
Pull-up for I/O
Number
Value
Rev 1 Dec. 17
Figure 13-2: ACEmanager: I/O > Configuration
Description
Displays the number of pull-ups. The corresponding hardware pins are:
Pull-up
1 Pin 4 on Power connector
Controls the internal pull-up resistor on the I/O line. Options are:
Disable—The pull-up is disabled. (Default)
•
Enable—The pull-up is enabled.
•
The pull-up voltage is based on V
Note: You cannot enable the Pull-up for I/O if the I/O line is already being used for
Standby mode.
Note: During bootup, the I/O settings remain in their default state: the internal pull-up
resistor is disabled, and output current sink switch is open. After bootup, any custom I/O
settings are applied. This may take approximately 30 seconds after the gateway is
restarted or powered on.
303
Corresponding hardware pin
. For details, refer to the Hardware User Guide.
in
I/O Configuration
41111088