Sierra Wireless AirLink RV50 Series User Manual page 285

Rev 1 Dec. 17
For Receiving TCP/IP Packets:
a. Expand the +TCP section of the screen.
Figure 11-13: ACEmanager: Serial > Port Configuration > TCP
b. Set the TCP Answer field to Enable.
For Receiving UDP/IP Packets:
a. Expand the +UDP section of the screen.
Figure 11-14: ACEmanager: Serial > Port Configuration > UDP
b. Set the UDP Answer field to Enable.
c. Set the Allow Any Incoming IP field to Allow Any IP. (If this field is left at
the default value, the AirLink gateway only accepts incoming UDP/IP
packets from the IP address specified in the Destination Address field in
the Port Configuration section of the screen.
10. For information on the other parameters, see
11. Click Apply.
12. Click Reboot (in the upper right of the screen).
13. Once the reboot is complete, this feature is enabled.
If the packet contents are not being sent to the connected device, see the
troubleshooting information in
285
Port Configuration
TCP/IP and UDP/IP Auto Answer
Serial Configuration
on page 264.
on page 497.
41111088