Table D-4: WAN / Cellular AT Commands
Command
*SIM1NETAPN
*SIM2NETAPN
*SIMPIN
Rev 1 Dec. 17
Query or set the user entered APN for the SIM card in SIM slot 1 (upper slot).
*SIM1NETAPN? to query
*SIM1NETAPN=<apn> to set the user entered APN (up to 80 characters)
Examples:
AT*SIM1NETAPN?
<apn>
OK
AT*SIM1NETAPN=<apn>
OK
Note: When you set this command, the APN type is automatically set to User Entry
so that the APN you enter with this AT command is used on reboot.
Query or set the user entered APN for the SIM card in SIM slot 2 (lower slot).
*SIM2NETAPN? to query
*SIM2NETAPN=<apn> to set the user entered APN (up to 80 characters)
Examples:
AT*SIM2NETAPN?
<apn>
OK
AT*SIM2NETAPN=<apn>
OK
Note: When you set this command, the APN type is automatically set to User Entry
so that the APN you enter with this AT command is used on reboot.
Sets the SIM PIN that ALEOS automatically entered if the ALEOS SIM PIN feature is
enabled. This should match the SIM PIN set on the SIM card, either by the mobile
network operator or by using *CHGSIMPIN. See
AT*SIMPIN=<pin> to enter the SIM pin
Example:
AT*SIMPIN=<pin>
OK
For the AirLink RV50 Series gateway, this command sets the Active SIM. Use
*SIM1PIN
or
*SIM2PIN
to set a specific SIM card, based on the slot it is installed in.
423
Description
*CHGSIMPIN
AT Commands
on page 410.
41111088